1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION
||Piston Power SHP(CI-4 Plus) 15W-40
||Oil for diesel and petrol engines
|Product safety guide:
2. HAZARD IDENTIFICATION
Injurious to health
No specific hazard under normal use conditions. Prolonged or repeated exposure may give rise to
dermatitis. Used oil may contain harmful impurities.
Not classified as flammable but will burn.
Not readily biodegradable. Expected to have high potential to bioaccumulate.
3. COMPOSITION AND INFORMATION ON INGREDIENTS
Blend of highly refined mineral oils and additives
On the basis of available information, the components of this preparation are not expected to impart
hazardous properties to this product.
4. FIRST AID
In severe cases : Not expected to give rise to an acute hazard under normal conditions of use.
Do not normally give rise to harmful vapours. However, In the unlikely event of dizziness or nausea,
remove casualty to fresh air. If symptoms persist, obtain medical attention.
Slight to moderate irritation. In case of irritation remove contaminated clothing and wash affected skin
with soap and water. If persistent irritation occurs, obtain medical advice.
Slightly irritating on repeated and prolonged exposure. In case of eye exposure flush eye with copious
quantities of water. Contact a doctor if irritation persists.
Aspiration into lungs gives rise to intense local irritation. This is not likely to arise during normal use. If
ingestion occurs, do not induce vomiting. Wash out mouth with water and obtain medical attention.
Treat symptomatically. Aspiration into lungs may cause chemical pneumonitis. Dermatitis may result
from prolonged and repeated exposure.
|Human Health Hazards:
||No specific hazards under normal use conditions.
Contains mineral oil for which an exposure limit for oil mist applies
Prolonged or repeated exposure may give rise to dermatitis.
Used oil may contain harmful impurities
||Not classified as flammable, but will burn.
||Not readily biodegradable. Expected to have a high potential to bio-accumulate.
||Not classified as dangerous for supply or conveyance.
6. FIRE FIGHTING MEASURES
Foam and dry chemical powder. Carbon dioxide, sand or earth should be used for small fires only.
Water in a jet must not be used.
Fire and Explosion hazards
Combustion is likely to give rise to airborne solids and liquid particulate and gases, including carbon
monoxide, oxides of sulphur, and unidentified organic and inorganic compounds
Special protective equipment
Proper protective equipment including breathing apparatus must be worn when approaching a fire in a
7. ACCIDENTAL RELEASE MEASURES
Avoid contact with skin. Wear impermeable gloves and boots. Nitrile rubber gloves.
Prevent from spreading and entering into drains, ditches or rivers by using sand, earth or other
Method of cleaning up
Small spills may be absorbed with sand or earth and removed to a suitable, clearly marked container
for disposal in accordance with local regulations.
Large spills must be prevented from spreading by making a barrier. Reclaim liquid directly or by
absorbing as for small spills.
8. HANDLING AND STORAGE
When handling product in drums, safety footwear should be worn and proper handling equipment
should be used.
Store in a cool, dry, well-ventilated place. Avoid direct sunlight, heat sources, and strong oxidising
9. PHYSICAL AND CHEMICAL PROPERTIES
||Liquid at ambient
||Greater than 300 C
||Less than --18 C
||Greater than 210 C
|Auto- Ignition Temperature
||Greater than 280 C
||Typically 0.885 Kg/L
||Less than 0.5Pa at 20 C
|Vapour Density (Air =1)
||Greater than 1 (estimated value)
|Greater than 6 (based on information on
||Typically 100 cSt at 40 C